Difference between revisions of "Hardware Overview"

From EOVSA Wiki
Jump to: navigation, search
(Equalizer Coefficients)
(Equalizer Coefficients)
Line 15: Line 15:
 
=== Equalizer Coefficients ===
 
=== Equalizer Coefficients ===
  
Each ROACH has a set of four registers named 'eq_x0_coeffs', 'eq_x1_coeffs', 'eq_x2_coeffs', and 'eq_x3_coeffs'.
+
Each ROACH has a set of four registers named 'eq_x0_coeffs', 'eq_x1_coeffs', 'eq_x2_coeffs', and 'eq_x3_coeffs'. The 'x0' and 'x1' coefficients correspond to the first antenna's X and Y polarization, respectively, while the 'x2' and 'x3' coefficients correspond to the second antenna.  I will refer to each of these as one of the ROACH's four '''IF channels,''' two for each antenna.  The correlator can tune successively to different 500 MHz '''IF bands,''' and each is divided into 4096 '''subchannels.'''

Revision as of 14:09, 9 April 2017

Frontend System

Figure 1: Two perspective views of the 2.1-m antenna front end feed package

The front end system (Figure 1) consists of a broadband (1-18 GHz) dual-polarization log-periodic crossed-dipole feed, and a thermally-controlled RF box (called the FEM, or Front End Module) that houses the amplifiers, calibration noise source (noise diode), attenuators, and optical transmitters needed to control the gain of the system and supply the two RF signals multiplexed onto a single optical fiber output.


Figure 2: The complete block diagram for the Front End Module (FEM) housed in the RF box

The block diagram for the FEM is shown in Figure 2.

Downconverter System

Figure 3: The complete block diagram for the Downconverter Module (DCM)

Digital Correlator

Digital Correlator

Equalizer Coefficients

Each ROACH has a set of four registers named 'eq_x0_coeffs', 'eq_x1_coeffs', 'eq_x2_coeffs', and 'eq_x3_coeffs'. The 'x0' and 'x1' coefficients correspond to the first antenna's X and Y polarization, respectively, while the 'x2' and 'x3' coefficients correspond to the second antenna. I will refer to each of these as one of the ROACH's four IF channels, two for each antenna. The correlator can tune successively to different 500 MHz IF bands, and each is divided into 4096 subchannels.